Scion IQ Forums banner
1 - 6 of 6 Posts

·
Registered
Joined
·
214 Posts
Discussion Starter · #1 ·
Adding footwell and rear area lights is easy. I will not do a install write up but i will show the needed connection point.

Parts:
(2) Puck Lights: STRIP_RL_12_W_6K
6K WHITE ROUND COURTESY PUDDLE STRIP LIGHT STRIPLIGHT 3 CHIP 12 LED
(1 or 2) Strip Lights
Strip Lights LED - 12 inch
(4) 48 Extensions wire
DIY-2 EXTENSION WIRE 48 INCH


Connection point:

Removing the drive side A-pillar panel.

Turn this clip 90degrees so it looks like the next picture (while the A-pillar is still installed)





It will look like this when the A-pillar comes off


Wire harness for connection


Connect your two wires from lights one to yellow and the other to black. Yellow is hot, black is ground when the doors is open.



Put car back together and your done.


Pictures:

Rear Area;






Drive side mounting;


Passenger side mounting:


 

·
Premium Member
Joined
·
2,831 Posts
Nice job. Simple and effective. Two thumbs up!

 

·
Registered
Joined
·
15 Posts
Does hooking your lights up here work with the dome light switch or just when the door is opened?
I found a post telling how to wire directly to the dome light switch,which is what I want for some of the lights Im installing, but thats not what I want for these lights.
Im installing some ghost shadow projector lights in the doors and I only want them on when the door is open. Only the door that is open.
Is there also a connector like this one on the passenger side?
Or do I have to wire them directly to the door switch.
 
1 - 6 of 6 Posts
Top